A lot of woodworkers think hearing loss only happens to old folks or people who go to loud concerts. They figure they are safe because they can still hear fine after a day in the shop. The problem is that hearing loss from power tools does not happen all at once. It builds up slowly, over years of exposure.
The Occupational Safety and Health Administration says that noise at or above 85 decibels can cause permanent damage over time. To put that in perspective, a normal conversation sits around 60 decibels. A lawnmower runs about 90 decibels. Many common woodworking tools easily push past 100 decibels. That means running a table saw or a planer for just a few hours without protection is doing real harm to the tiny hair cells inside your ears. Those cells do not grow back once they are damaged.
I have been a cabinetmaker in Wisconsin for many years, and the sounds of the shop are part of my daily life. The buzz of the saw, the hum of the router, the roar of the dust collector. It is the music of making things. But I learned the hard way that this music has a cost if you are not careful. I have tried different kinds of hearing protection in the woodshop. Foam earplugs are simple and they work well for short jobs. For longer stretches of loud work, like running a planer for hours, I prefer earmuffs. They create a better seal around the ear and block a wider range of noise.
The trick is to be consistent. It is easy to skip the earplugs for just one quick cut. But that one cut adds up over hundreds of cuts across many years. Making hearing protection a non-negotiable part of your routine is the only way to prevent cabinetmaker hearing loss. You have to treat earplugs or earmuffs the same way you treat safety glasses. You put them on before you start and you keep them on.
The research on shop noise woodworking is clear. Gradual hearing loss does more than make it hard to hear conversations. It can make it difficult to pick out speech in a noisy room, which leads to social isolation. It can also make it harder to hear subtle sounds from your machines, which might create safety hazards in the shop.
There are other good habits too. Keeping your tools well maintained helps them run quieter. Being thoughtful about the order of your work can reduce overlapping loud noises. And teaching younger woodworkers about the risks is something I take seriously.
The goal is to keep building furniture for a lifetime. That satisfaction should never come with the price of not being able to hear your grandchildren laugh or the wind in the trees. Understanding the risk of shop noise and using protection every time keeps the workshop a place of joy, not regret.
There is a fuller write-up at hearing research woodworkers.